51
Predefined user roles
network-admin
Parameters
hsi: Specifies the High-Speed Internet (HSI) service. This service is applicable to PPP, 802.1X, and
IPoE leased line users.
stb: Specifies the Set Top Box (STB) service. This service is applicable to STB users.
voip: Specifies the Voice over IP (VoIP) service. This service is applicable to IP phone users.
Usage guidelines
You can configure only one service type for one ISP domain.
When the HSI service is specified, the multicast feature of the access module is disabled to save
system resources.
When the STB service is specified, the multicast feature of the access module is enabled to improve
the performance of the multicast module.
When the VoIP service is specified, the QoS module increases the priority of voice traffic to reduce
the transmission delay for IP phone users.
For 802.1X, PPP (excluding PPPoE), and IPoE leased line users, the system uses the HSI service
forcibly even if the STB or VoIP service is specified.
Examples
# Specify the STB service for users in ISP domain test.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] service-type stb
session-time include-idle-time
Use session-time include-idle-time to configure the device to include the idle cut period (or the
online detection interval for portal users) in the user online duration sent to the server.
Use undo session-time include-idle-time to restore the default.
Syntax
session-time include-idle-time
undo session-time include-idle-time
Default
The device does not include the idle cut period or online detection interval in the user online duration
sent to the server.
Views
ISP domain view
Predefined user roles
network-admin
Usage guidelines
Configure the idle cut period feature based on the accounting policy in your network.
If the user goes offline due to connection failure or malfunction, the user online duration sent to the
server is not the same as the actual online duration.
To Next Page
Loading...
Need help?
General
