850
FTP 21 UDP IPv4 subnet 10.10.10.1/24
FTP 21 SCTP IPv6 host 2000:fdb8::1:00ab:853c:39ab
HTTP 899 TCP IPv4 ACL 2002
HTTP 999 SCTP IPv6 ACL 2002
Table 129 Command output
Application Application protocol using port mapping.
Port Port number to which the application protocol is mapped.
Protocol Transport layer protocol.
Match Type
Match types:
• ---—No match types or match conditions are specified, and
all packets that have the specified port are recognized as
the packets of the specified application protocol.
• IPv4 host—A match based on the destination IPv4
addresses of the packet.
• IPv6 host—A match based on the destination IPv6
addresses of the packet.
• IPv4 subnet—A match based on the destination IPv4
subnet of the packet.
• IPv6 subnet—A match based on the destination IPv6
subnet of the packet.
• IPv4 ACL—A match based on the IPv4 ACL.
• IPv6 ACL—A match based on the IPv6 ACL.
Match Condition
Match conditions:
• For the match type of IPv4 host or IPv6 host, the destination
IP addresses of the packets are displayed.
• For the match type of IPv4 subnet or IPv6 subnet, the
destination subnet addresses of the packets are displayed.
• For the match type of IPv4 ACL or IPv6 ACL, the correct
ACL number is displayed.
For IP address-based and subnet-based host-port mappings, the
MPLS L3VPN instance names are displayed if you configured
them.
include application
Use include application to add application protocols to an application group.
Use undo include application to remove application protocols from an application group.
Syntax
include application application-name
undo include application application-name
Default
An application group does not contain any application protocols.
Views
Application group view
To Next Page
Loading...
