331
Usage guidelines
Before you execute this command, make sure the client traffic forwarding location is at APs.
Examples
# Set the interval at which an AP reports traffic statistic to the device to 120 seconds.
<Sysname> system-view
[Sysname] portal client-traffic-report interval 120
Related commands
client forwarding-location (WLAN Command Reference)
portal delete-user
Use portal delete-user to log out online portal users.
Syntax
portal delete-user { ipv4-address | all | auth-type { cloud | email | local | normal | qq | wechat } |
interface interface-type interface-number | ipv6 ipv6-address | mac mac-address | username
username }
Views
System view
Predefined user roles
network-admin
Parameters
ipv4-address: Specifies the IP address of an IPv4 online portal user.
all: Specifies IPv4 and IPv6 online portal users on all interfaces.
auth-type: Specifies online portal users by the authentication type.
cloud: Specifies the cloud authentication.
email: Specifies the email authentication.
local: Specifies the local authentication.
normal: Specifies the normal authentication.
qq: Specifies the QQ authentication.
wechat: Specifies the WeChat authentication.
The following matrix shows the auth-type { cloud | email | local | normal | qq | wechat } option and
hardware compatibility:
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-Po
E/810-LM-HK/810-W-LM-HK/810-LMS/810-LUS
No
MSR2600-10-X1 Yes
MSR 2630 Yes
MSR3600-28/3600-51 Yes
MSR3600-28-SI/3600-51-SI Yes
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC Yes
MSR 3610/3620/3620-DP/3640/3660 Yes
To Next Page
Loading...
