H3C MSR Series

920
<Sysname> system-view
[Sysname] connection-limit policy 1
[Sysname-connlmt-policy-1]
# Create IPv6 connection limit policy 12 and enter its view.
<Sysname> system-view
[Sysname] connection-limit ipv6-policy 12
[Sysname-connlmt-ipv6-policy-12]
Related commands
connection-limit apply
connection-limit apply global
display connection-limit
limit
connection-limit apply
Use connection-limit apply to apply a connection limit policy to an interface.
Use undo connection-limit apply to remove the application.
Syntax
connection-limit apply { ipv6-policy | policy } policy-id
undo connection-limit apply { ipv6-policy | policy }
Default
No connection limit policy is applied to an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-policy: Specifies an IPv6 connection limit policy.
policy: Specifies an IPv4 connection limit policy.
policy-id: Specifies the ID of a connection limit policy. The value range for this argument is 1 to 32.
Usage guidelines
Only one IPv4 connection limit policy and one IPv6 connection limit policy can be applied to an
interface. A new IPv4 or IPv6 connection limit policy overwrites the old one.
Examples
# Apply IPv4 connection limit policy 1 to GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] connection-limit apply policy 1
# Apply IPv6 connection limit policy 12 to GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] connection-limit apply ipv6-policy 12