1102
Predefined user roles
network-admin
Parameters
all: Removes all the static IPv6SG bindings on the interface.
ip-address ipv6-address: Specifies an IPv6 address for the static binding. The IPv6 address cannot
be an all-zero address, a multicast address, or a loopback address.
mac-address mac-address: Specifies a MAC address for the static binding. The MAC address must
be in H-H-H format, and cannot be all 0s, all Fs (a broadcast MAC address), or a multicast MAC
address.
vlan vlan-id: Specifies a VLAN ID for the static binding. The value range is 1 to 4094.
Usage guidelines
IMPORTANT:
Static IPv6SG bindings that contain MAC addresses are not supported on
Layer 2 Ethernet ports on
the following modules:
• HMIM-8GSW.
• HMIM-8GSWF.
• HMIM-24GSW.
• HMIM-24GSWP.
Static IPv6SG bindings that contain IP addresses or VLANs are not supported on the following
routers:
• MSR810.
• MSR810-W.
• MSR810-W-DB.
• MSR810-LM.
• MSR810-W-LM.
• MSR810-10-PoE.
• MSR810-LM-HK.
• MSR810-W-LM-HK.
•
Static IPv6SG bindings on an interface filter incoming IPv6 packets on the interface.
You cannot configure static IPv6SG bindings on a service loopback interface.
Examples
# Configure a static IPv6SG binding on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ipv6 source binding ip-address 2001::1 mac-address
0002-0002-0002
Related commands
display ipv6 source binding
ipv6 verify source
Use ipv6 verify source to enable both static and dynamic IPv6SG on an interface.
To Next Page
Loading...
