299
Type
Type of the Web redirect rule:
• Static—Static Web redirect rule, generated when the Web redirect
feature takes effect.
• Dynamic—Dynamic Web redirect rule, generated when a user visits a
redirect webpage.
Action
Action in the Web redirect rule:
• Permit—Allows packets to pass.
• Redirect—Redirects the packets.
Status
Status of the Web redirect rule:
• Active—The Web redirect rule is effective.
• Inactive—The Web redirect rule is not effective.
Source Source information in the Web redirect rule.
IP Source IP address.
Mask Subnet mask of the source IPv4 address.
Prefix length Prefix length of the source IPv6 address.
VLAN Source VLAN. If not specified, this field displays
Any
.
Protocol
Transport layer protocol in the Web redirect rule:
• Any—No transport layer protocol is limited.
• TCP—Transmission Control Protocol.
Destination Destination information in the Web redirect rule.
Port Destination transport layer port number. The default port number is 80.
exclude-attribute (MAC binding server view)
Use exclude-attribute to exclude an attribute from portal protocol packets.
Use undo exclude-attribute to not exclude an attribute from portal protocol packets.
Syntax
exclude-attribute attribute-number
undo exclude-attribute attribute-number
Default
No attributes are excluded from portal protocol packets.
Views
MAC binding server view
Predefined user roles
network-admin
Parameters
attribute-number: Specifies an attribute by its number in the range of 1 to 255.
Usage guidelines
Support of the portal authentication server for portal protocol attributes varies by the server type.
During MAC-trigger authentication, the device and the server cannot communicate if the device
sends the portal authentication server a packet that contains an attribute unsupported by the server.