184
Parameters
supp-timeout-value: Specifies the SmartOn client timeout timer in seconds. The value range is 10 to
120.
Usage guidelines
The SmartOn client timeout timer starts when the device sends an EAP-Request/Notification packet
to the client. If the device does not receive any EAP-Response/Notification packets from the client
within the timer interval, it retransmits the EAP-Request/Notification packet. After the device has
made the maximum retransmission attempts but received no response, it stops the 802.1X
authentication process for the client. To set the maximum retransmission attempts, use the dot1x
smarton retry command.
Examples
# Set the SmartOn client timeout timer to 20 seconds.
<Sysname> system-view
[Sysname] dot1x smarton timer supp-timeout 20
Related commands
display dot1x
dot1x smarton retry
dot1x timer
Use dot1x timer to set an 802.1X timer.
Use undo dot1x timer to restore the default of an 802.1X timer.
Syntax
dot1x timer { ead-timeout ead-timeout-value | handshake-period handshake-period-value |
quiet-period quiet-period-value | reauth-period reauth-period-value | server-timeout
server-timeout-value | supp-timeout supp-timeout-value | tx-period tx-period-value }
undo dot1x timer { ead-timeout | handshake-period | quiet-period | reauth-period |
server-timeout | supp-timeout | tx-period }
Default
The following 802.1X timers apply:
• EAD rule timer: 30 minutes.
• Handshake timer: 15 seconds.
• Quiet timer: 60 seconds.
• Periodic reauthentication timer: 3600 seconds.
• Server timeout timer: 100 seconds.
• Client timeout timer: 30 seconds.
• Username request timeout timer: 30 seconds.
Views
System view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General
