588
Predefined user roles
network-admin
Parameters
aggressive: Specifies the aggressive mode.
main: Specifies the main mode.
Usage guidelines
As a best practice, specify the aggressive mode at the local end if the following conditions are met:
• The local end, for example, a dialup user, obtains an IP address automatically.
• Pre-shared key authentication is used.
Examples
# Specify that IKE negotiation operates in main mode.
<Sysname> system-view
[Sysname] ike profile 1
[Sysname-ike-profile-1] exchange-mode main
Related commands
display ike proposal
ike address-group
Use ike address-group to configure an IKE IPv4 address pool for assigning IPv4 addresses to
remote peers.
Use undo ike address-group to delete an IKE IPv4 address pool.
Syntax
ike address-group group-name start-ipv4-address end-ipv4-address [ mask | mask-length ]
undo ike address-group group-name
Default
No IKE IPv4 address pools exist.
Views
System view
Predefined user roles
network-admin
Parameters
group-name: Specifies a name for the IKE IPv4 address pool, a case-insensitive string of 1 to 63
characters.
start-ipv4-address end-ipv4-address: Specifies an IPv4 address range. The start-ipv4-address
argument specifies the start IPv4 address. The end-ipv4-address argument specifies the end IPv4
address.
mask: Specifies the IPv4 address mask.
mask-length: Specifies the length of the IPv4 address mask.
Usage guidelines
An IKE IPv4 address pool can contain a maximum of 8192 IPv4 addresses.
To Next Page
Loading...
