107
Predefined user roles
network-admin
Parameters
profile-name: Specifies the name of the test profile, which is a case-sensitive string of 1 to 31
characters.
username name: Specifies the username in the detection packets. The name argument is a
case-sensitive string of 1 to 253 characters.
interval interval: Specifies the interval for sending a detection packet, in minutes. The value range
for the interval argument is 1 to 3600, and the default value is 60.
Usage guidelines
You can execute this command multiple times to configure multiple test profiles.
If you specify a nonexistent test profile for a RADIUS server, the device does not detect the status of
the server until you create the test profile on the device.
You can specify the same test profile for multiple RADIUS servers.
When you delete a test profile, the device stops detecting the status of the RADIUS servers that use
the test profile.
Examples
# Configure a test profile named abc for RADIUS server status detection. The detection packet uses
admin as the username and is sent every 10 minutes.
<Sysname> system-view
[Sysname] radius-server test-profile abc username admin interval 10
Related commands
primary authentication (RADIUS scheme view)
secondary authentication (RADIUS scheme view)
reset radius statistics
Use reset radius statistics to clear RADIUS statistics.
Syntax
reset radius statistics
Views
User view
Predefined user roles
network-admin
Examples
# Clear RADIUS statistics.
<Sysname> reset radius statistics
Related commands
display radius statistics
To Next Page
Loading...
Need help?
General
