511
Usage guidelines
You can configure different descriptions for IPsec policies, IPsec policy templates, or IPsec profiles
to distinguish them.
Examples
# Configure the description for IPsec policy 1 as CenterToA.
<Sysname> system-view
[Sysname] ipsec policy policy1 1 isakmp
[Sysname-ipsec-policy-isakmp-policy1-1] description CenterToA
display ipsec { ipv6-policy | policy }
Use display ipsec { ipv6-policy | policy } to display information about IPsec policies.
Syntax
display ipsec { ipv6-policy | policy } [ policy-name [ seq-number ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
ipv6-policy: Displays information about IPv6 IPsec policies.
policy: Displays information about IPv4 IPsec policies.
policy-name: Specifies an IPsec policy by its name, a case-insensitive string of 1 to 63 characters.
seq-number: Specifies an IPsec policy entry by its sequence number in the range of 1 to 65535.
Usage guidelines
If you do not specify any parameters, this command displays information about all IPsec policies.
If you specify an IPsec policy name and a sequence number, this command displays information
about the specified IPsec policy entry. If you specify an IPsec policy name without any sequence
number, this command displays information about all IPsec policy entries with the specified name.
Examples
# Display information about all IPv4 IPsec policies.
<Sysname> display ipsec policy
-------------------------------------------
IPsec Policy: mypolicy
-------------------------------------------
-----------------------------
Sequence number: 1
Mode: Manual
-----------------------------
The policy configuration is incomplete:
ACL not specified
Incomplete transform-set configuration
Description: This is my first IPv4 manual policy
To Next Page
Loading...
Need help?
General
