246
User-dhcp-only
Status of the user-dhcp-only feature:
• Enabled: Only users with IP addresses obtained through DHCP can
perform portal authentication.
• Disabled: Both users with IP addresses obtained through DHCP and
users with static IP addresses can pass authentication to get online.
Pre-auth ip-pool
Name of the IP address pool specified for portal users before
authentication.
Max portal users Maximum number of portal users allowed on an interface.
Bas-ip
BAS-IP attribute of the portal packets sent to the portal authentication
server.
Bas-ipv6
BAS-IPv6 attribute of the portal packets sent to the portal authentication
server.
User detection
Configuration for online detection of portal users on the interface,
including detection method (ARP, ICMP, ND, or ICMPv6), detection
interval, maximum number of detection attempts, and user idle time.
Portal temp-pass
Status of the temporary pass feature:
• Enabled—The temporary pass feature is enabled.
• Disabled—The temporary pass feature is disabled.
• Period—Temporary pass period during which a user can access the
Internet temporarily. This field is displayed only if the temporary pass
feature is enabled.
Action for server detection
Portal server detection configuration on the interface:
• Server type—Type of the server. Portal server represents the portal
authentication server, and Web server represents the portal Web
server.
• Server name—Name of the server.
• Action—Action triggered by the result of server detection. This field
displays fail-permit when the portal fail-permit feature is enabled.
Layer3 source subnet Information of the portal authentication source subnet.
Destination authentication
subnet
Information of the portal authentication destination subnet.
IP address IP address of the portal authentication subnet.
Mask Subnet mask of the portal authentication subnet.
Prefix length Prefix length of the IPv6 portal authentication subnet address.
display portal auth-error-record
Use display portal auth-error-record to display portal authentication error records.
Syntax
display portal auth-error-record { all | ipv4 ipv4-address | ipv6 ipv6-address | start-time
start-date start-time end-time end-date end-time }
Views
Any view
Predefined user roles
network-admin