954
Default
Rule matching acceleration is disabled for an object policy.
Views
Object policy view
Predefined user roles
network-admin
Usage guidelines
Insufficient hardware resources cause acceleration failures. When the system has sufficient
hardware resources, acceleration can take effect again under either of the following conditions:
• You change or add rules for the policy.
• You use this command to enable rule matching acceleration again.
After you enable rule matching acceleration, the following situations might occur:
• Acceleration fails, and the matching process runs without acceleration.
• Acceleration succeeds, and the matching process is accelerated. In this scenario, if you change
or add a rule that causes resource insufficiency, the rule does not take effect.
Examples
# Disable rule matching acceleration for IPv4 object policy op.
<Sysname> system-view
[Sysname] object-policy ip op
[Sysname-object-policy-ip-op] undo accelerate
Related commands
display object-policy accelerate
description
Use description to configure a description for an object policy.
Use undo description to restore the default.
Syntax
description text
undo description
Default
No description is configured for an object policy.
Views
Object policy view
Predefined user roles
network-admin
Parameters
text: Specifies a description, a case-sensitive string of 1 to 127 characters.
Usage guidelines
If the object policy does not have a description, this command configures the description. Otherwise,
this command overwrites the existing description for the policy.
To Next Page
Loading...
Need help?
General
