H3C MSR Series

811
Views
System view
Predefined user roles
network-admin
Parameters
aspf-policy-number: Assigns a number to the ASPF policy. The value range for this argument is 1 to
256.
Examples
# Create ASPF policy 1 and enter its view.
<Sysname> system-view
[Sysname] aspf policy 1
[Sysname-aspf-policy-1]
Related commands
display aspf all
display aspf policy
detect
Use detect to configure ASPF inspection for an application layer protocol.
Use undo detect to restore the default.
Syntax
detect { { dns [ action { drop | logging } * ] | ftp | h323 | http | sccp | sip | smtp } [ action drop ] |
gtp | ils | mgcp | nbt | pptp | rsh | rtsp | sqlnet | tftp | xdmcp }
undo detect { dns | ftp | gtp | h323 | http | ils | mgcp | nbt | pptp | rsh | rtsp | sccp | sip | smtp |
sqlnet | tftp | xdmcp }
Default
ASPF does not inspect application layer protocols. ASPF inspects only transport layer protocols.
Views
ASPF policy view
Predefined user roles
network-admin
Parameters
dns: Specifies DNS, an application layer protocol.
ftp: Specifies FTP, an application layer protocol.
gtp: Specifies GPRS Tunneling Protocol (GTP), an application layer protocol.
h323: Specifies H.323 protocol stack, application layer protocols.
http: Specifies HTTP, an application layer protocol.
ils: Specifies Internet Locator Service (ILS), an application layer protocol.
mgcp: Specifies Media Gateway Control Protocol (MGCP), an application layer protocol.
nbt: Specifies NetBIOS over TCP/IP (NBT), an application layer protocol.
pptp: Specifies Point-to-Point Tunneling Protocol (PPTP), an application layer protocol.