1048
undo dns-flood detect { ip ipv4-address | ipv6 ipv6-address } [ vpn-instance vpn-instance-name ]
Default
IP address-specific DNS flood attack detection is not configured.
Views
Attack defense policy view
Predefined user roles
network-admin
Parameters
ip ipv4-address: Specifies the IPv4 address to be protected. The ipv4-address argument cannot be
255.255.255.255 or 0.0.0.0.
ipv6 ipv6-address: Specifies the IPv6 address to be protected.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN instance to which the protected IP
address belongs. The vpn-instance-name argument is a case-sensitive string of 1 to 31 characters.
Do not specify this option if the protected IP address is on the public network.
port port-list: Specifies a space-separated list of up to 65535 port number items for a protected IPv4
address or a protected IPv6 address. Each item specifies a port by its port number or a range of ports
in the form of start-port-number to end-port-number. The end-port-number cannot be smaller than
the start-port-number. If you do not specify this option, the global ports apply.
threshold threshold-value: Specifies the threshold for triggering DNS flood attack prevention. The
value range is 1 to 1000000 in units of DNS packets sent to the specified IP address per second.
action: Specifies the actions when a DNS flood attack is detected. If no action is specified, the global
actions set by the dns-flood action command apply.
client-verify: Adds the victim IP addresses to the protected IP list for DNS client verification. If DNS
client verification is enabled, the device provides proxy services for protected servers.
drop: Drops subsequent DNS packets destined for the protected IP address.
logging: Enables logging for DNS flood attack events.
none: Takes no action.
Usage guidelines
With DNS flood attack detection configured for an IP address, the device is in attack detection state.
When the sending rate of DNS packets to the IP address reaches the threshold, the device enters
prevention state and takes the specified actions. When the rate is below the silence threshold
(three-fourths of the threshold), the device returns to the attack detection state.
Examples
# Configure DNS flood attack detection for 192.168.1.2 in the attack defense policy atk-policy-1.
<Sysname> system-view
[Sysname] attack-defense policy atk-policy-1
[Sysname-attack-defense-policy-atk-policy-1] dns-flood detect ip 192.168.1.2 port 53
threshold 2000
Related commands
dns-flood action
dns-flood detect non-specific
dns-flood threshold
dns-flood port
To Next Page
Loading...
Need help?
General
