EasyManuals Logo

H3C MSR Series Command Reference

H3C MSR Series
1187 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1137 background imageLoading...
Page #1137 background image
1114
Syntax
arp detection rule rule-id { deny | permit } ip { ip-address [ mask ] | any } mac { mac-address
[ mask ] | any } [ vlan vlan-id ]
undo arp detection rule [ rule-id ]
Default
No user validity check rule is configured.
Views
System view
Predefined user roles
network-admin
Parameters
rule-id: Assigns an ID to the user validity check rule. The ID value range is 0 to 511. A smaller value
represents a higher priority.
deny: Denies matching ARP packets.
permit: Permits matching ARP packets.
ip { ip-address [ mask ] | any }: Specifies the sender IP address as the match criterion.
ip-address: Specifies an IP address in dotted decimal notation.
mask: Specifies the address mask in dotted decimal notation. If you do not specify the mask,
the ip-address argument specifies a host IP address.
any: Matches any IP address.
mac { mac-address [ mask ] | any }: Specifies the sender MAC address as the match criterion.
mac-address: Specifies a MAC address in the H-H-H format.
mask: Specifies the MAC address mask in the H-H-H format. If you do not specify the mask, the
argument specifies the host MAC address.
any: Matches any MAC address.
vlan vlan-id: Specifies the ID of a VLAN to which the specified rule applies. The value range for the
vlan-id argument is 1 to 4094. If you do not specify a VLAN, the rule applies to all VLANs.
Usage guidelines
A user validity check rule takes effect only when ARP attack detection is enabled.
If you do not specify a rule ID, the undo arp detection rule command deletes all user validity check
rules.
Examples
# Configure a user validity check rule and enable ARP detection for VLAN 2.
<Sysname> system-view
[Sysname] arp detection rule 0 permit ip 10.1.1.1 255.255.0.0 mac 0001-0203-0405
ffff-ffff-0000
[Sysname] vlan 2
[Sysname-vlan2] arp detection enable
Related commands
arp detection enable

Table of Contents

Other manuals for H3C MSR Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C MSR Series and is the answer not in the manual?

H3C MSR Series Specifications

General IconGeneral
CategoryNetwork Router
IPv6 SupportYes
DimensionsVaries by model
WeightVaries by model
Product TypeModular Router
PortsVaries by model
WAN InterfacesVaries by model
FirewallYes
QoSYes
Wireless SupportVaries by model
USB PortsVaries by model
Console PortYes
Power SupplyVaries by model
RedundancyVaries by model
Operating Temperature0°C to 45°C
Storage Temperature-40°C to 70°C
Humidity5% to 95% non-condensing
SeriesMSR
CertificationsCE, FCC, RoHS

Related product manuals