240
Syntax
display portal { ap ap-name [ radio radio-id ] | interface interface-type interface-number }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
ap ap-name: Specifies an AP by its name, a case-insensitive string of 1 to 64 characters. Valid
characters are letters, digits, underscores (_), left brackets ([), right brackets (]), slashes (/), and
minus signs (-).
radio radio-id: Specifies a radio by its ID. The value range for the radio ID varies by device model. If
you do not specify a radio, this command displays portal configuration and portal running state for all
radios of the AP.
The following matrix shows the ap ap-name [ radio radio-id ] option and hardware compatibility:
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-
10-PoE/810-LM-HK/810-W-LM-HK
Yes
MSR810-LMS/810-LUS No
MSR2600-10-X1 Yes
MSR 2630 Yes
MSR3600-28/3600-51 Yes
MSR3600-28-SI/3600-51-SI No
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-D
P-DC
No
MSR 3610/3620/3620-DP/3640/3660 Yes
MSR5620/5660/5680 No
interface-type interface-number: Specifies an interface by its type and number.
Examples
# Display portal configuration and portal running state on GigabitEthernet 1/0/1. (Wired application.)
<Sysname> display portal interface gigabitethernet 1/0/1
Portal information of GigabitEthernet1/0/1
NAS-ID profile: aaa
VSRP instance : instance1
VSRP state : Master
Authorization : Strict checking
ACL : Enabled
User profile : Disabled
Dual stack : Disabled
Dual traffic-separate: Disabled
IPv4:
Portal status: Enabled
To Next Page
Loading...
Need help?
General
