297
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
ap ap-name: Specifies an AP by its name, a case-insensitive string of 1 to 64 characters. Valid
characters are letters, digits, underscores (_), left brackets ([), right brackets (]), slashes (/), and
minus signs (-).
radio radio-id: Specifies a radio by its ID. The value range for the radio ID varies by device model. If
you do not specify a radio, this command displays portal filtering rules for all radios of the AP.
The following matrix shows the ap ap-name [ radio radio-id ] option and hardware compatibility:
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-P
oE/810-LM-HK/810-W-LM-HK
Yes
MSR810-LMS/810-LUS No
MSR2600-10-X1 Yes
MSR 2630 Yes
MSR3600-28/3600-51 Yes
MSR3600-28-SI/3600-51-SI No
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC No
MSR 3610/3620 /3620-DP/3640/3660 Yes
MSR5620/5660/5680 No
interface interface-type interface-number: Specifies an interface by its type and number.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
displays Web redirect rules for the active MPU. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays Web redirect rules for the master device. (Centralized devices in IRF
mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number
argument represents the slot number of the card. If you do not specify a card, this command displays
Web redirect rules for the global active MPU. (Distributed devices in IRF mode.)
Examples
# Display all Web redirect rules on GigabitEthernet 1/0/1. (Wired application.)
<Sysname> display web-redirect rule interface gigabitethernet 1/0/1
IPv4 web-redirect rules on GigabitEthernet1/0/1:
Rule 1:
Type : Dynamic
Action : Permit
Status : Active
Source:
IP : 192.168.2.114
To Next Page
Loading...
