H3C MSR Series

343
Syntax
portal free-rule rule-number { destination ip { ip-address { mask-length | mask } | any } [ tcp
tcp-port-number | udp udp-port-number ] | source ip { ip-address { mask-length | mask } | any } [ tcp
tcp-port-number | udp udp-port-number ] } * [ interface interface-type interface-number ]
portal free-rule rule-number { destination ipv6 { ipv6-address prefix-length | any } [ tcp
tcp-port-number | udp udp-port-number ] | source ipv6 { ipv6-address prefix-length | any } [ tcp
tcp-port-number | udp udp-port-number ] } * [ interface interface-type interface-number ]
undo portal free-rule { rule-number | all }
Default
No IP-based portal-free rule is configured.
Views
System view
Predefined user roles
network-admin
Parameters
rule-number: Specifies a portal-free rule number. The value range for this argument is 0 to
4294967295.
destination: Specifies the destination information.
source: Specifies the source information.
ip ip-address: Specifies an IPv4 address for the portal-free rule.
{ mask-length | mask }: Specifies the subnet mask of the IPv4 address. The value range for the
mask-length argument is 0 to 32. The mask argument is in dotted decimal format.
ipv6 ipv6-address: Specifies an IPv6 address for the portal-free rule.
prefix-length: Specifies the prefix length of the IPv6 address, in the range of 0 to 128.
ip any: Represents any IPv4 address.
ipv6 any: Represents any IPv6 address.
tcp tcp-port-number: Specifies a TCP port number for the portal-free rule, in the range of 0 to 65535.
udp udp-port-number: Specifies a UDP port number for the portal-free rule, in the range of 0 to
65535.
all: Specifies all portal-free rules.
interface interface-type interface-number: Specifies a Layer 3 interface on which the portal-free rule
takes effect.
Usage guidelines
You can specify both the source and destination keyword for a portal-free rule. If you specify only
one keyword, the other keyword does not act as a filtering criterion.
If you specify both a source port number and a destination port number for a portal-free rule, the two
port numbers must belong to the same transport layer protocol.
If you do not specify a Layer 3 interface, the portal-free rule takes effect on all portal-enabled
interfaces.
You cannot configure two portal-free rules with the same filtering criteria.
Examples
# Configure an IPv4-based portal-free rule:
• Set the rule number to 1.