742
Bandwidth Expected bandwidth for the interface.
Maximum transmission unit MTU of the interface.
Internet protocol processing
IP address of the interface.
If no IP address is assigned to the interface, this field displays
Internet protocol processing: Disabled
, and the interface cannot
process packets.
Primary
indicates that the IP address is the primary IP address of
the interface.
Last clearing of counters
Most recent time the counters were cleared by using the
reset
counters interface
command.
If the
reset counters interface
command has never been
executed since the device starts up, this field displays
Never
.
Last 300 seconds input rate Average input rate in the last 300 seconds.
Last 300 seconds output rate Average output rate in the last 300 seconds.
# Display brief information about all SSL VPN AC interfaces.
<Sysname> display interface sslvpn-ac brief
Brief information of interfaces in route mode:
Link: ADM - administratively down
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
SSLVPN-AC1000 UP DOWN --
# Display brief information about SSL VPN AC 1000, including the complete interface description.
<Sysname> display interface sslvpn-ac 1000 brief description
Brief information of interfaces in route mode:
Link: ADM - administratively down
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
SSLVPN-AC1000 UP UP 1.1.1.1 SSLVPN-AC1000 Interface
# Display information about interfaces in DOWN state and the causes.
<Sysname> display interface sslvpn-ac brief down
Brief information on interfaces in route mode:
Link: ADM - administratively down
Interface Link Cause
SSLVPN-AC1000 ADM
SSLVPN-AC1001 ADM
Table 107 Command output
Brief information of interfaces
in route mode:
Brief information about Layer 3 interfaces.
Link: ADM - administratively
down
Link status.
ADM
indicates that the interface has been shut down by using
the
shutdown
command. To restore the physical state of the interface, use
the
undo shutdown
command.
Protocol: (s) - spoofing
(s)
indicates that the data link layer protocol state is UP, but the link is
temporarily set up on demand or does not exist.