MAINTENANCE AN D SERVICING
10. At the cam end, install endshield support (A) at
applicable tine tube location on the cam end.
11. Reinstall reel endshields. Refer to 5.13.6 Reel
Endshields, page 369.
Figure 5.225: Cam End
Center Disc and Tail End Bushings
12. Position bushing halves (B) on tine tube with flangeless
end adjacent to reel arm, and locate lug in each
bushinghalfinholeintinetube.
13. Slide reel arm (A) onto bushing (B) and position against
disc at original location.
14. Reinstall any fingers or tines that were removed.
Refer to:
• Install
ing Steel Tines, page 356
• Install
ing Plastic Fingers, page 357
Figure 5
.226: Tail End
15. Install bushing clamp (A) onto tine tube adjacent to
flangeless end of bushing (B).
16. Position clamp (A) on bushings (B) so that edges
of clamp and bushing are flush when clamp fi ts into
groove on bushing and lock tabs are engaged.
Figu
re 5.227: Bushing
147695 365 Revision A
To Next Page
Loading...
