NEC Univerge SV9100 - To Return Call from Inmail; To Return Call from the UM8000 Mail

101
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
14-01-22
Basic Trunk Data Setup – Caller
ID to Voice Mail
Enable/Disable the system ability
to send the Caller ID digits to voice
mail.
Trunks 1 ~ 400
0 = Disable
1 = Enable
0
14-02-10
Analog Trunk Data Setup – Caller
ID
Enable (1)/Disable (0) a trunk to
receive Caller ID information.
Trunks 1 ~ 400
0 = Off (Caller ID not displayed.)
1 = On (Caller ID is displayed.)
0
15-02-04
Multiline Telephone Basic Data
Setup – Redial (Speed Dial)
Control
Control the function of the
extension Redial key when used
with Speed Dialing. The Redial key
can access either the Common or
Group Speed Dialing numbers.
0 = Common Abbreviated Dial
1 = Group Speed Dialing
0
Operation
To return call from the UM8000 Mail:
1. While listening to a message with CID information press More, More then Call softkeys.
- OR -
Dial #, 0.
2. To exit from the call, hang up.
To return call from InMail:
1. While listening to a message with CID information press More, More then Call softkeys.
- OR -
Dial 6, 2 (MC).
2. To exit from the call, hang up.
 If you hear “Your call cannot go through,” your system Caller ID is not properly set up. You will be
returned to the listen mode for the message you were listening to when you tried the Make Call.