NEC Univerge SV9100 - IP Phone Configuration

737
Program
Number
Program Name/Description
Input Data
Default
84-20-03
SIP Extension Basic Information Setup –
Minimum Session Timer Value
Define the minimum allowed value for the SIP
session timer.
1 ~ 65535
180
84-20-04
SIP Extension Basic Information Setup –
Called Party Info
Define the SIP Extension presented Caller ID
information.
0 = Request URI
1 = To Header
0
84-20-05
SIP Extension Basic Information Setup –
Expire Value of Invite
Define the time out response value for SIP
invite.
0 ~ 256 seconds
180
84-26-01
IPL Basic Setup – IP Address
Assign the IP address for each DSP on the
GPZ-IPLE.
xxx.xxx.xxx.xxx
172.16.0.20
84-26-02
IPL Basic Setup – RTP Port Number
Assign the RTP port number to be used for
each DSP on the GPZ-IPLE.
Only even numbered ports are supported.
0 ~ 65534
10020
84-26-03
IPL Basic Setup – RTCP Port Number (RTP
Port Number + 1)
Define the TCP port number for RTCP to use
for each DSP.
0 ~ 65534
10021
IP Phone Configuration:
Program
Number
Program Name/Description
Input Data
Default
15-01-01
Basic Extension Data Setup – Extension
Name
Define the extension/virtual extension name.
Maximum of 12 characters.
STA 101 = Ext
101
STA 102 = Ext
102, etc.
15-05-02
IP Telephone Terminal Basic Data Setup – IP
Phone Fixed Port Assignment
MAC Address of registered MLT SIP phone is
stored and/or can input the MAC address of an
MLT SIP phone so when it comes online it is
provided with the extension which the MAC
address matches.
MAC address
00-00-00-00-00-00 to
FF-FF-FF-FF-FF-FF
00-00-00-00-00-
00
15-05-07
IP Telephone Terminal Basic Data Setup –
Using IP Address
Review the registered IP Phones IP Address
[Informational Only].
0.0.0.0 ~ 255.255.255.255
0.0.0.0