NEC Univerge SV9100 - Park Intercom or Trunk Calls; To Park a Call at Your Extension; To Park a Call in a System Orbit; To Pick up a Parked Call

966
Operation
To Park a call in a system orbit:
You can Park Intercom or trunk calls.
1. Press the Park key (Program 15-07 or SC 852: *04 + orbit).
 The Park key LED lights.
 If you hear busy tone, the orbit is busy. Try another orbit.
2. Use Paging to announce call.
3. Press Speaker to hang up.
 If not picked up, the call recalls to you.
- OR -
1. At the multiline terminal or 2-button telephone, press Hold.
- OR -
At a 500/2500 single line telephone, hookflash.
2. Dial #6 and the Park orbit (01~64).
 If you hear busy tone, the orbit is busy. Try another orbit.
 If you hear a busy tone, the orbit is busy. Dial #6* if enabled in Program 20-11-27 (Call Park
AutoSearching) to search for an idle park location in ascending order.
3. Use Paging to announce the call.
4. Press Speaker to hang up.
 If not picked up, the call recalls to you.
 The parked call recalls after the Park Hold Time (Program 24-01-06). The call rings the extension to
which it recalled for the Hold Recall Callback Time (Program 24-01-02). The call then goes on Hold
for the Park Hold Time, then recalls again for the Hold Recall Callback Time. The call continues to
cycle between Hold and recall until the extension user answers the call or the outside party hangs up.
To pick up a parked call:
1. Lift the handset.
2. Press the Park key (Program 15-07 or SC 852: *04 + orbit).
- OR -
1. At the multiline terminal or 2-button telephone, press Speaker.
- OR -
At single line telephone, lift the handset.
2. Dial *6 and the Park orbit (01~64).
To park a call at your extension:
1. Press Hold and dial 773.