NEC Univerge SV9100 - Selectable Display Message - Character Entry Chart; To Cancel a Message; To Select a Message

1064
Selectable Display Message – Character Entry Chart
Use this keypad digit . . . When you want to. . .
1
Enter characters:
1 @ [ ¥
]
^
_
‘
{
|
}
>
<
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, a-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “ #
$
%
&
<space> (
)
*
Enter characters:
* + , - .
/
:
;
< = >
?
#
Accepts a numeric entry from the user when setting a display message.
e.g., time or date. Back at ##:##
Feature
Clear the character entry one character at a time (when using service code or
function key).
Recall
Clear the character entry one character at a time (when in telpro).
Hold
Clear all the entries from the point of the flashing cursor and to the right.
Operation
To select a message:
1. Press Speaker + press the Text Message key (Program 15-07 or SC 851: 18) + enter digits to
append (if needed) + Speaker to hang up. Skip the remaining steps.
2. (Optional for messages 1~8 and 10.)
Dial the digits you want to append to the message.
 You can append messages 1~8 and 10 with digits (e.g., the time when you will be back). Enter the time
in 24-hour format.
3. Press Speaker to hang up.
 Intercom calls to extensions with Selectable Display Messaging set receive a DND signal and receive
the display message on their telephone display instead of ringing the extension based on the setting in
Program 20-01-02.
 To allow calls to ring through and have the message displayed on the calling extension display, cancel
DND by pressing DND feature key + 0.
To cancel a message:
1. Press Speaker and the Text Message key (Program 15-07 or SC 851: 18).
2. Press Speaker to hang up.