NEC Univerge SV9100 - Trunk Disconnect Continue;Disconnect Codes

1207
Trunk Disconnect Continue/Disconnect Codes:
Program
Number
Program Name/Description
Input Data
Default
14-01-25
Basic Trunk Data Setup – Continued/
Discontinued Trunk-to-Trunk Conversation
Enable/Disable the ability to dial a service code
to continue or disconnect the trunk-to-trunk
conversation after the alert tone is heard.
0 = Disable
1 = Enable
0
20-28-01
Trunk to Trunk Conversation – Conversation
Continue Code
Input the code that can be dialed to continue
the conversation after the Trunk-to-Trunk
Release Warning tone is heard.
0 ~ 9, #, *
No Setting
20-28-02
Trunk to Trunk Conversation – Conversation
Disconnect Code
Input the code that can be dialed to disconnect
the conversation after the Trunk-to-Trunk
Release Warning tone is heard.
0 ~ 9, #, *
No Setting
20-28-03
Trunk to Trunk Conversation – Conversation
Continue Time
Input the time the conversation extends when
the Conversation Continue Code is dialed.
0 ~ 64800 seconds
0
24-02-07
System Options for Transfer – Trunk-to-
Trunk Transfer Release Warning Tone
This timer starts when a trunk begins talking
with another trunk (for example: Trunk-to-Trunk
Transfer/Tandem Trunking). When this time
expires, a warning tone is heard. If Program
24-02-10 is set, the conversation disconnects
after time expires. This time is set again when
the external digit timer expires. One of the
trunks used must be an analog trunk (or leased
line).
0 ~ 64800 seconds
1800