306
Cordless Telephone Connection
Description
When using an APR-L for DTL telephones a cordless telephone (2500-type) can be connected to a
multiline terminal.
The GCD-4LCF with GPZ-4LCF Daughter Board, GCD-8LCF with GPZ-8LCF Daughter Board also
support cordless telephones, but this feature refers to multiline terminal cordless connection.
Conditions
A voice announced internal call to the multiline terminal does not ring the cordless
telephone.
Only one cordless single line telephone can be connected to an APR-L Unit.
When CO Prime Line is assigned to the associated multiline terminal, internal dial tone
cannot be transferred to the cordless telephone.
The cordless telephone requires a PBR circuit while dialing. When all PBR circuits are busy,
a busy tone is heard when the phone goes off-hook.
Depending on your environment, the maximum number of cordless devices used without
interference varies.
This feature works with 2500-type cordless single line telephones.
The multiline terminal user and the associated cordless telephone user cannot talk to each
other.
An APR-L Unit with hookflash enabled follows the same operating procedures as a single
line
terminal connected to a GCD-4LCF with GPZ-4LCF Daughter Board or GCD-8LCF with
GPZ-
8LCF Daughter Board.
The multiline terminal LCD displays normal information for multiline terminal when a
cordless terminal is used.
When the multiline terminal user goes off-hook before the cordless single line telephone
user, a PBR circuit is not connected for the cordless single line telephone.
The cordless telephone must be installed within 10 feet of the APR-L Unit.
The following features are supported by an APR-L:
Initiate conference
Change station name
Privacy release by pressing line key
Group Listen
DSS/BLF indication
Headset Ringing
The APR-L only support DTMF signaling, DP (Dial Pulse) is not supported.
To Next Page
Loading...
