1012
Programmable Function Keys
Assign a function key for Repeat Redial
(code 29).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
Class of Service Options (Outgoing Call
Service) – Repeat Redial
Turn Off or On an extension to use Repeat
Redial.
Repeat Dial Setup – Repeat Redial Count
Set how many times Repeat Redial
automatically repeats if the call does not go
through.
Repeat Dial Setup – Repeat Redial Interval
Time
Set the time between Repeat Redial attempts.
Repeat Dial Setup – Repeat Dial Calling
Timer
Set the time the system waits for the called
party to answer after a Repeat Redial. If the
called party does not answer in this time, the
system hangs up and tries again (after the
Repeat Redial Interval Time). For unanswered
calls, the total time between retries is the sum
of Program 21-08-02 and Program 21-08-03.
Repeat Dial Setup – Time for Send Busy
Tone for ISDN Trunk
Set the time to send out Busy Tone with an
ISDN line, when called party is busy.
Operation
To use Repeat Redial (if the outside party you call is unavailable or busy):
1.
Place a trunk call.
Listen for busy tone or ring no answer.
2.
Press Feature + Redial.
- OR -
Press the Repeat Redial key (Program 15-07 or SC 851: 29).
Repeat Redial key flashes while you wait for the system to redial.
3.
Press Speaker to hang up.
The system periodically redials the call.
4.
Lift the handset when called party answers.
When using trunks with answer supervision the Repeat Redial feature automatically cancels.
To Next Page
Loading...
