242
Guide to Feature Programming
Service Code Setup (for System
Administration) – Dial Block by Supervisor
Assign a service code used by the supervisor to
set Dial Block for another extension.
MLT
0 ~ 9,
*
, # Maximum of eight
digits
Service Code Setup (for Setup/Entry
Operation) – Dial Block
Assign a service code to use for Dial Block.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to
extensions.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
Class of Service Options (Outgoing Call
Service) – Toll Restriction Dial Block
Turn Off or On an extension user ability to use
Dial Block.
Toll Restriction Override Password Setup
Assign Toll Restriction Override codes to
extensions. Each code must have four digits,
using any combination of 0 ~ 9, # and *. Each
extension can have a separate code, or many
extensions can share the same override code.
Maximum of four digits (fixed)
Dial Block Setup – Toll Restriction Class
with Dial Block
Assign a Code Restriction COS (1 ~ 15) when
the Dial Block feature is used.
Dial Block Setup – Supervisor Password
Assign a 4-digit password used by the
supervisor to enable or disable Dial Block for
other extensions.
0 ~ 9, *, #
(4-digit fixed)
Dial Block restriction Class per Extension
Assign the Code Restriction COS (1 ~ 15) used
by an extension when the Dial Block feature is
enabled. If this data is 0, Code Restriction COS
follows Program 21-09-01.
0, 1 ~ 15
(0 = No Setting)
Dial Block Release
Enter the extension number to release from the
Dial Block Restriction. This program can be
used when a password is forgotten by the user.
[Release?]: Dial 1+ press
Transfer
(Press Transfer to cancel.)
Operation
To set Dial Block:
1.
At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2.
Dial 700 (default).
To Next Page
Loading...
