NEC Univerge SV9100 - To Change a Handset Call to a Handsfree Call; To Talk Handsfree

534
Related Features
Central Office Calls, Answering
Central Office Calls, Placing
Microphone Cutoff
Prime Line Selection
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
15-02-08
Multiline Telephone Basic Data Setup –
Automatic Handsfree
Set whether pressing a key accesses a
One-Touch Key or preselects the key.
0 = Preselect
1 = One-Touch (Automatic
Handsfree)
1
15-02-16
Multiline Telephone Basic Data Setup –
Handsfree Operation
Enable/Disable an extension user ability to use
the speakerphone on outside calls. When
disabled, the user can hear the conversion, but
cannot respond handsfree.
0 = Disable
1 = Enable
1
20-02-12
System Options for Multiline Telephones –
Forced Intercom Ring (ICM Call Type)
Enable/Disable Forced Intercom Ringing. If
enabled, incoming Intercom calls normally ring.
If disabled, Intercom calls voice-announce.
0 = Disable (Voice)
1 = Enable (Signal)
0
20-06-01
Class of Service for Extensions
Assign Class of Service (1 ~ 15) for extensions.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
20-09-05
Class of Service Options (Incoming Call
Service) – Signal/Voice Call
Turn Off or On an extension user ability to
enable Handsfree Answerback or Forced
Intercom Ringing for their incoming Intercom
calls.
0 = Off
1 = On
COS 1 ~ 15 = 1
Operation
To talk Handsfree:
1. Press Speaker, Trunk Line key or Virtual Extension key.
2. Place the call.
3. Speak toward the telephone when the called party answers.
To change a handset call to a Handsfree call:
1. Press Speaker and hang up the handset.