NEC Univerge SV9100 - Store a System Speed Dialing Number under a Programmable Function Key; To Dial a System Speed Dialing Number

1116
Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^
_
`
{
|
}
Æ
¨
Á
À
Â
Ã
Ç
É
Ê
ì
ó
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, d-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $
%
&
’
(
)
ô
Õ
ú ä ö ü



*
Enter characters:
* + , - .
/
:
; <
=
>
?
π
Σ 
Ω
∞
¢
£
#
# = Accepts an entry (only required if two letters on the same key are needed - ex: TOM).
Pressing # again = Space. (In system programming mode, use the right arrow Softkey
instead to accept and/or add a space.)
Feature
Clear the character entry one character at a time.
HOLD (Telpro only)
Clear all the entries from the point of the flashing cursor and to the right.
7. Press Hold.
8. Press Speaker to hang up or repeat steps 3~7 to program another System or Group Speed Dial
bin.
To dial a System Speed Dialing number:
1. Go off-hook.
2. Press Redial.
- OR -
Press the Right Cursor key until the Group Speed Dial menu appears.
3. Dial the System Speed Dialing storage code.
 Unless you preselect, Trunk Group Routing selects the trunk for the call. The system may optionally
select a specific Trunk Group for the call.
 If you have a DSS Console, you may be able to press a DSS Console key to chain to a stored number.
To store a System Speed Dialing number under a Programmable Function Key:
1. At multiline terminal, press Speaker.
2. Dial 851.
3. Press the key where the number is to be stored.