229
Tie Line Code Restriction Enhanced
In Program 34-01-05: E&M Tie Line Basic Setup – System Code Restriction, if this option is
set to 0, the system follows the setting in Program 21-05-13: Code Restriction Class –
Restriction of Tie Line Calls to determine whether or not the Code restriction setting in
Program 34-08 is to be followed. If this option is set to 1, the system follows the system
Code restriction settings defined in Program 21-05-01 through Program 21-05-13.
A user can temporarily override extension Code Restrictions.
The system allows or denies outgoing access to trunks depending on Code Restriction.
If the system detects the call is answered by detecting reversal in an analog trunk this
restores both – way voice paths immediately.
When using DISA or Tie Lines, additional programming is required for Code Restriction
(DISA, refer to Program 25-10; Tie Lines, refer to Program 34-04).
A user can temporarily block their extension Code Restriction access, preventing unwanted
calls from being placed on their telephone while they are away from their desk.
Each phone and trunk have a Restriction Class. The higher class applies for outgoing calls.
For example:
When trunk class is 01 and station class 02, Toll Restriction Class 02 is applied.
When trunk class is 15 and station class 03, Toll Restriction Class 15 is applied.
Default Settings
Disabled
System Availability
Terminals
All Terminals
Required Component(s)
None
Related Features
Central Office Calls, Placing
Code Restriction Override
Code Restriction, Dial Block
Direct Inward System Access (DISA)
PBX Compatibility
Multiple Trunk Types
To Next Page
Loading...
