NEC Univerge SV9100 - To Perform an ISDN 2 B-Channel Transfer

807
Program
Number
Program Name/Description
Input Data
Default
20-11-14
Class of Service Options (Hold/Transfer
Service) – Trunk-to-Trunk Transfer
Restriction
Turn Off or On the Trunk-to-Trunk Transfer
Restriction. If enabled, Trunk-to-Trunk Transfer
is impossible.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-11-21
Class of Service Options (Hold/Transfer
Service) – Restriction for Tandem Trunking
on Hang Up
Allow/Deny an extension user ability to set up a
tandem/ conference call automatically when
they hang up.
0 = Allow
1 = Deny
COS 1 ~ 15 = 0
20-25-15
ISDN Options – Call Reference Selection for
PRI 2 B-Channel Transfer
Turn ON (1) or OFF (0) the ability for an
incoming call to be transferred (Trunk-to-Trunk)
to an outgoing call when 2 B-Channel Transfer
is used.
0 = Negative Integer
1 = No Edit
0
24-02-09
System Options for Transfer – Two
B-Channel Transfer Retry Timer
Enable/Disable disconnect Supervision for the
system trunks.
0 ~ 64800 seconds
10
Operation
To Perform an ISDN 2 B-Channel Transfer:
1. Receive or make an ISDN trunk call.
2. Go off-hook using the handset, or press Speaker (the Call Appearance key or direct trunk
appearance lights). Talk with the outside party.
3. Press the Transfer key.
4. Dial 9 to access second ISDN trunk.
5. Dial the outside number and wait for the outside party to answer.
6. Hang up.
7. LCD returns to idle after the LCD Display Hold timeout (Program 20-02-08).