NEC Univerge SV9100 - Page 806

806
Program
Number
Program Name/Description
Input Data
Default
20-13-23
Class of Service Options (Supplementary
Service) – Display the Reason for Transfer
Select whether or not an extension should
display the reason a call is being transferred to
their extension (Call Forward Busy, Call
Forward No Answer, DND).
0 = Off
1 = On
COS 1 ~ 15 = 0
20-19-04
System Options for Caller ID – Wait Facility
IE Timer
This is the time an ISDN trunks uses to
determine the time the system waits for the
Caller ID name from the Telco.
0 ~ 64800 seconds
10
20-25-14
ISDN Options – No response Release Send
Operation mode setting for when second T303
timer expires.
0 = Off
1 = On
0
ISDN 2 B-Channel Transfer:
Program
Number
Program Name/Description
Input Data
Default
10-03-16
ETU Setup – PRI Service Two B-Channel
Transfer
Turn On or Off the ability to use the ISDN-PRI 2
B-Channel Transfer service.
0 = Off
1 = On
0
14-01-13
Basic Trunk Data Setup – Trunk-to-Trunk
Transfer
If DISA caller can place outgoing calls through
the system (refer to Program 20-14), Enable
loop supervision for the DISA trunk. If DISA
caller cannot use the system trunks for
outgoing calls, enter Disable.
0 = Disable
1 = Enable
2
15-07-01
Programmable Function Keys
Assign function to multiline terminal line keys
(Transfer = 06).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
20-02-08
System Options for Multiline Telephones –
LCD Display Holding Time
Determine the time a user display shows Caller
ID for a second incoming call.
0 ~ 64800 seconds
5
20-11-11
Class of Service Options (Hold/Transfer
Service) – Automatic On-Hook Transfer
Turn Off or On an extension user ability to use
Automatic On-Hook Transfer.
0 = Off
1 = On
COS 1 ~ 15 = 0