NEC Univerge SV9100 - Page 805

805
General ISDN Programs:
Program
Number
Program Name/Description
Input Data
Default
14-01-13
Basic Trunk Data Setup – Trunk-to-Trunk
Transfer
For each trunk that should be able to participate
in a tandem call, enter 1. To disable a trunk
from Tandem Trunking, enter 0. Required for 2
B-Channel transfer.
0 = Disable
1 = Enable
1
15-02-29
Multiline Telephone Basic Data Setup – PB
Back Tone Level
Adjust the PB Back Tone level when calling an
ISDN line.
1 ~ 63 (-15.5dB ~ +15.5dB)
32 (0dB)
15-07-01
Programmable Function Keys
Assign a function key for Caller ID Block for
ISDN (63) if required.
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
20-06-01
Class of Service for Extensions
Assign a Class of Service to extensions.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
20-09-02
Class of Service Options (Incoming Call
Service) – Caller ID Display
Turn Off or On the Caller ID display at an
extension.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-09-03
Class of Service Options (Incoming Call
Service) – Sub Address Identification
Define whether or not an extension displays the
Caller Sub-Address.
0 = Deny
1 = Allow
COS 1 ~ 15 = 0
20-11-11
Class of Service Options (Hold/Transfer
Service) – Automatic On-Hook Transfer
Turn Off or On an extension user ability to
transfer when the user hangs up.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-11-14
Class of Service Options (Hold/Transfer
Service) – Trunk-to-Trunk Transfer
Restriction
Turn Off or On the Trunk-to-Trunk Transfer
Restriction. If enabled, Trunk-to-Trunk Transfer
is impossible.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-11-21
Class of Service Options (Hold/Transfer
Service) – Restriction for Tandem Trunking
on Hang Up
Allow an extension user to set up a tandem call
automatically when they hang up.
0 = Deny
1 = Allow
COS 1 ~ 15 = 0