NEC Univerge SV9100 - DID Services for Either ISDN - BRI or PRI

802
Program
Number
Program Name/Description
Input Data
Default
21-12-01
ISDN Calling Party Number Setup for Trunks
– Calling Party Number Data
Assign Calling Party Numbers for each trunk
(maximum 16 digits per entry).
After the above programming is complete a
reset of the GCD-PRTA is required.
Maximum of 16 characters
(1 ~ 0, *, #)
No Setting
DID Services for either ISDN – BRI or PRI:
Program
Number
Program Name/Description
Input Data
Default
22-02-01
Incoming Call Trunk Setup
Assign the incoming trunk type for each trunk.
Trunks 1 ~ 400
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
0
22-09-01
DID Basic Data Setup – Expected Number of
Digits
For each DID Translation Table (1 ~ 20), enter
the number of digits the table expects to receive
from the CO (eight maximum). For example, for
a table used with 3-digit DID service, enter 3.
For additional DID Services refer to Direct
Inward Dialing (DID) .
1 ~8
4
22-11-01
DID Translation Number Conversion –
Received Number
For each DID Translation Table entry
(1 ~ 4000), specify the digits received by the
system.
Maximum of eight digits.
No Setting
22-11-02
Translation Number Conversion – Target
Number
For each DID Translation Table entry
(1 ~ 4000), specify the extension the system
dials after translation.
Maximum of 24 digits.
No Setting