NEC Univerge SV9100 - To Answer an Incoming Trunk Group Call; To Place a Call over a Trunk Group

1236
Program
Number
Program Name/Description
Input Data
Default
21-01-05
System Options for Outgoing Calls –
Disconnect Time When Dial Tone Not
Detected
If 14-02-11 is enabled, the system skips over a
trunk if dial tone is not detected. This option
pertains to calls placed using Speed Dial, ARS,
Last Number Redial or Save Number dialed. It
does not pertain to line key or Direct Trunk
Access calls.
0 ~ 64800 seconds
3
Operation
To place a call over a trunk group:
1. At the multiline telephone, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 804.
3. Dial trunk group number (1~9 or 001~100).
4. Dial number.
- OR -
1. Press the Trunk Group key (Program 15-07 or SC 852: *02 + group).
2. Dial the number.
To answer an incoming trunk group call:
1. Lift the handset.
2. Press the flashing Trunk Group key.