NEC Univerge SV9100 - To Dial a Station Speed Dialing Number (Multiline Terminal); To Store a Station Speed Dialing Number

1118
To store a Station Speed Dialing number (display telephones only):
1. Press Speaker.
2. Dial 855.
3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
" " " " " "
0 = Station Speed Dial buffer 10
4. Dial the telephone number you want to store (up to 24 digits).
 Valid entries are 0~9, # and *. To enter a pause, press MIC. To store a Flash, press Recall.
5. Press Hold.
6. Enter the name associated with the Speed Dialing number (display telephones only). Refer to
Keys for Entering Names.
7. Press Hold.
8. Press Speaker to hang up.
To store a Station Speed Dialing number (Single Line Telephones only):
1. Lift the Handset.
2. Dial 855.
3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1= Station Speed Dial Buffer 1
2= Station Speed Dial Buffer 2
3= Station Speed Dial Buffer 3
4= Station Speed Dial Buffer 4
5 = Station Speed Dial Buffer 5
6 = Station Speed Dial Buffer 6
7 = Station Speed Dial Buffer 7
8 = Station Speed Dial Buffer 8
9 = Station Speed Dial Buffer 9
0 = Station Speed Dial Buffer 10
4. Dial the telephone number you want to store (up to 24 digits).
 Valid entries are 0~9, # and *.
 A Single line set cannot program a pause or flash in a spd bin.
5. Hang up.
To dial a Station Speed Dialing number (multiline terminal):
1. Press Speaker.
2. Dial #7 (default Service Code).
3. Dial the Station Speed Dial buffer number (0 ~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
: : : : : : :
0 = Station Speed Dial buffer 10
 The stored number dials out.
 Unless you preselect, Trunk Group Routing selects the trunk for the call. The system may optionally