NEC Univerge SV9100 - To Store an Speed Dialing Number (Display Telephones Only)

1115
Program
Number
Program Name/Description
Input Data
Default
80-04-07
Call Progress Tone Detector Setup – ON
maximum time
Define the on maximum time for the Call
Progress Tone Detector.
0 ~ 255 (30+30-7680ms)
Type 1 (DT) – 0
Type 2 (BT) – 20
(450ms) [ET]
Type 3 (RBT) –
40 1230ms)
Type 4, Type 5 –
0
80-04-08
Call Progress Tone Detector Setup – OFF
minimum time
Define the off minimum time for the Call
Progress Tone Detector.
1 ~ 255 (30+30-7680ms)
Type 1 (DT) – 1
(60ms)
Type 2 (BT) – 12
(300ms)
Type 3 (RBT) –
83 (2520ms)
Type 4, Type 5 –
0
80-04-09
Call Progress Tone Detector Setup – OFF
maximum time
Define the off maximum time for the Call
Progress Tone Detector.
0 ~ 255 (30+30-7680ms)
Type 1 (DT) – 1
(60ms)
Type 2 (BT) – 20
(450ms)
Type 3 (RBT) –
115 (3480ms)
Type 4, Type 5 –
0
Operation
To store an Speed Dialing number (display telephones only):
1. Press Speaker.
2. Dial 853 (for system) or 854 (for group).
3. Dial system or group storage code.
 Initially, there are 1000 System Speed Dialing codes. There are Group Speed Dialing codes only if you
define them in programming.
4. Dial telephone number you want to store (up to 24 digits).
 Valid entries are 0~9, # and *. To enter a pause, press Transfer. To store a Flash, press Recall.
 Enter @ for await answer before sending following digits on ISDN.
5. Press Hold.
6. Enter the name associated with the Speed Dialing number.