1384
Off-Hook Signaling
Description
This feature enables the display of off-hook signaling on an IP DECT terminal while talking
with the 1st
call.
DECT – 2nd Indication
Conditions
Multiple call appearance and call waiting indication must be turned on for the
SIP DECT
system using the IP DECT configurator V 5.0.1.4 or higher.
Program 20-13-54 must be turned on for the class of service the DECT telephone
is in.
If Program 20-13-06 is set on, IP DECT receives an off-hook signaling
automatically. If
Program 20-13-06 is set off, the 2nd caller hears a busy tone. If
the override code is dialed
(Program 11-12-03 SC 709) and overrides SC
(Program 11-12-03), then the IP DECT
receives off-hook signals manually.
Off-hook signaling is supported from an extension, voicemail and trunk call.
If a SIP DECT extension is talking to a voice mail port, the system does not send
an
off-hook signal. Once the SIP DECT disconnects from voice mail, SIP DECT can
answer
the 2nd call.
If the 1st call is an extension and the 2nd call is a voice mail, IP DECT answers
the 2nd call
by pressing the * button, but can not go back to the 1st call by
pressing the * button. To
reconnect to the1st call again, IP DECT has to
disconnect the 2nd call and wait for recall of
the 1st call.
With SV9100 software and GPZ-IPLE daughter board installed, half duplex
To Next Page
Loading...
