NEC Univerge SV9100 - Flexible Timeouts

504
Flexible Timeouts
Description
The Flexible Timeouts feature provides a variety of timers in the Resident System Program to allow the
system to operate without initial programming. The system timers can be changed to meet customer
needs according to the system application requirements.
A Timer Class is used to allow terminals and trunks to have different timers for the same feature. There
are 16 timer Classes (0~15). The following table shows the Programs that are used depending on the
Timer Class used:
Timer
Class 0
Timer
Class 1~15
Title
Comment
20-01-08
20-31-01
Trunk Queuing Callback Time
Trunk Queuing callback rings an extension for this
time. Station Timer Class is referred by the station
that sets trunk queuing.
20-01-09
20-31-02
Callback / Trunk Queuing
Cancel Time
The system cancels an extension Callback or Trunk
Queuing request after this time. Station Timer Class
is referred by the station that sets an extension
Callback or Trunk Queuing.
20-04-03
20-31-03
CAR/SIE/Virtual Extension
Delay Interval
If CAR/VE is set for Delayed Ringing (Program
15-11-01), ring the covering extension after this time.
Station Timer Class is referred by the station assigned
to CAR/VE.
21-01-02
20-31-04
Intercom Interdigits Time
When placing Intercom calls, users must dial each
digit in this time. Station Timer Class is referred by
stations. Trunk Timer Class is referred by DID/
Automatic Answer Trunk/E&M trunks.
21-01-03
20-31-05
Trunk Interdigits Time
When placing CO calls, users must dial each digit in
this time. Station Timer Class is referred by stations.
Trunk Timer Class is referred by DID/Automatic
Answer Trunk/E&M trunks.
21-01-09
20-31-06
Hotline Time Start Time
A Ringdown extension automatically calls its
programmed destination after this time. Station Timer
Class is referred by the stations which sets Hotline.
22-01-03
20-31-07
Ring No Answer Alarm Time
If a trunk rings a key telephone longer than this time,
the system changes the ring cadence. This indicates
to the user that the call was ringing too long. Trunk
Timer Class is referred by the trunk.
22-01-04
20-31-08
DIL No Answer Recall Time
A DIL that rings its programmed destination longer
than this time diverts to the DIL No Answer Ring
Group (Program 22-08-01). Trunk Timer Class is
referred by the trunk.