NEC Univerge SV9100 - Direct Call by Time Schedule

371
Program
Number
Program Name/Description
Input Data
Default
25-07-13
System Timers for VRS/DISA – VRS/DISA
Busy Tone Interval
If a DISA caller dials a busy extension (and
Program 25-04-01 is set to 0), the system plays
busy tone for this time before disconnecting.
0 ~ 64800 seconds
5
25-07-14
System Timers for VRS/DISA – Delayed VRS
Answer Time
Assign the delay time from switching from a
normal incoming status to DID mode. If this
time is set to 0, the call switches to DID mode
immediately.
0 ~ 64800 seconds
10
34-01-01
E&M Tie Line Basic Setup – DID/E&M Start
Signaling
Set the start signaling mode for DID and tie
trunks. DID and tie trunks can use either
immediate start or wink start signaling.
0 = 2nd Dial Tone
1 = Wink (default)
2 = Immediate
3 = Delay
1
34-01-02
E&M Tie Line Basic Setup – Receive Dial
Type for E&M Tie Line
For DID and tie trunks, set the trunks signaling
type.
0 = DP
1 = DTMF
2 = MF
1
Direct Call by Time Schedule:
Program
Number
Program Name/Description
Input Data
Default
11-10-35
Service Code Setup (for Administrator) –
Dial-In Mode Switching
Assign the service code Dial-In Mode
Switching.
MLT, SLT
0 ~ 9,
*
, # Maximum of eight
digits
No Setting
12-04-01
Holiday Night Service Switching
Define a yearly schedule of holiday night-switch
settings. This schedule is used for the setting of
special days when the company is expected to
be closed, such as a national holiday.
Night Mode Service Group No.
01-32
Days and Months
0101 ~ 1231
Time Pattern No.
0 ~ 10
0 = No Setting
No Setting
15-07-01
Programmable Function Keys
Assign a function key for one-touch access to
the Dial-In Mode Switching setup code (Code
88).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
20-07-26
Class of Service Options (Administrator
Level) – Dial-In Mode Switch
Enable/ Disable an extension user ability to
manually change Dial-In Modes.
0 = Off
1 = On
COS 1 ~ 15 = 0