NEC Univerge SV9100 - To Place a Serial Call to a Co-Worker

1071
Guide to Feature Programming
Program
Number
Program Name/Description
Input Data
Default
15-02-05
Multiline Telephone Basic Data Setup –
Transfer Key Operation Mode
Set the operating mode of the extension
Transfer key. The keys can be for Call Transfer,
Serial Calling or Flash. When selecting Flash
(2), refer also to Program 81-01-14.
0 = Transfer
1 = Serial Call
2 = Flash
0
15-07-01
Programmable Function Keys
Assign a programmable key as a Serial Call key
(code 43).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
Operation
To place a Serial Call to a co-worker:
1. Place or answer a call.
2. Press Hold or Transfer.
3. Dial co-worker’s extension number.
 Co-worker must lift the handset to respond to your announcement.
4. Press the Serial Call key (Program 15-07 or SC 851: 43).
-OR-
5. Press Transfer key if Program 15-02-05 is set to Call Back (Serial Call).
6. When the multiline terminal display shows WAIT TRF extension can hang up.
 When your co-worker hangs up the call, the system makes an automatic live transfer back to your
extension.