NEC Univerge SV9100 - Clock;Calendar Display

223
Clock/Calendar Display
Description
The system uses Clock/Calendar Display for:
Central Office Calls (Access Maps)
Station Message Detail Recording
Class of Service (Class)
System Reports
Direct Inward Lines
Toll Restriction (Class)
Display Telephones
Trunk Group Routing
Night Service (Automatic)
Voice Mail
Programmable Trunk Parameters
Voice Response System
Ring Groups
Using the Daylight Savings Setup program, you can determine whether the system should automatically
adjust the system time for daylight savings time/standard time changes.
Clock Adjustment
The system can be programmed to automatically adjust the system clock on a nightly basis. This feature
allows you to make adjustments should the system cabinet regularly lose or gain time.
Conditions
The system retains the Clock/Calendar Display after a power failure or system reset.
Changing the time may change the current Class of Service (COS) service depending on
the COS mode setup.
You can program the system to automatically switch modes.
Single line telephones cannot set the time and date.
Changing the system time automatically changes the InMail time.
Default Settings
Enabled