NEC Univerge SV9100 - To Establish Conference

247
Program
Number
Program Name/Description
Input Data
Default
20-11-21
Class of Service Options (Hold/Transfer
Service) – Restriction for Tandem Trunking
on Hang Up
Allow/Deny an extension users’ ability to set up
a tandem/conference call automatically when
they hang up.
0 = Allow
1 = Deny
COS 1 ~ 15 = 0
20-13-08
Class of Service Options (Supplementary
Service) – Conference
Turn Off or On an extension user ability to
initiate a conference or Meet Me Conference.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-13-10
Class of Service Options (Supplementary
Service) – Barge-In Monitor
Enable the Barge-In Speech Mode or Monitor
Mode at the initiating extension (i.e., Barge-In
initiator).
0 = Speech
1 = Monitor
COS 1 ~ 15 = 0
20-13-15
Class of Service Options (Supplementary
Service) – Barge-In, Initiate
Turn Off or On an extension user ability to
barge-in on other's calls.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-13-16
Class of Service Options (Supplementary
Service) – Barge-In, Receive
Turn Off or On Barge-In at the receiving
extension (i.e., Barge-In receive).
0 = Off
1 = On
COS 1 ~ 15 = 0
20-14-11
Class of Service Options for DISA/E&M –
DISA/Tie Trunk Barge-In
Enable (1)/Disable (0) a DISA or tie trunk user
from using the Barge-In feature.
0 = Off
1 = On
COS 1 ~ 15 = 0
Operation
To establish Conference: Multiline
Terminal
1. Establish intercom or trunk call.
2. Press Conf or Conf softkey (Program 15-07 or SC 851: 07).
3. Dial the extension you want to add.
- OR -
Access outside call.
- OR -
Retrieve call from Park orbit.
 To get the outside call, you can either press a line key or press the Speaker key and dial 9, the Trunk
Access Code + the trunk number (default #9). You can optionally go back to step 2 to add more
parties to your Conference.
4. When called party answers, press the Add softkey or Conf twice.
 If you cannot add additional parties to your Conference, you have exceeded the system Conference
limit.
 If the call being added is busy/unanswered: