NEC Univerge SV9100 - Tandem Trunking on Hang up Multiline

1209
2. Press Speaker or hang up.
 If Program 20-13-10 is set to 0, the Conference ends and the line keys go out.
 If Program 20-13-10 is set to 1, to manually disconnect the Conference, Forced Trunk Disconnect (i.e.,
Press the line key + *3 or the service code set of Forced Trunk Disconnect in Program 11-10-26) must be
used by an extension other than the originating extension.
Method B – Tandem Trunking with Transfer Key
Multiline Terminal:
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press Hold to place the first trunk call on hold.
3. Place a second trunk call.
4. Press Transfer.
 This sets up an Unsupervised Conference with both outside parties.
 The line keys for the trunks light solid red.
 To disconnect the Conference, use Forced Trunk Disconnect (i.e., Press the line key + *3 or the service
code set of Forced Trunk Disconnect in Program 11-10-26) must be used by an extension other than
the originating extension.
Single Line Telephone:
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press hookflash and dial #1.
3. Place or answer second trunk call.
4. To set up the tandem call, press hookflash and dial 753.
5. Hang up.
 This sets up a Conference between both outside parties.
Method C – Tandem Trunking on Hang up Multiline
Terminal:
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press Hold to place the first trunk call on hold.
3. Place a second trunk call.
4. Hang up.
 This sets up an Unsupervised Conference with both outside parties.
 The line keys for the trunks light solid red.
 To disconnect the Conference, use Forced Trunk Disconnect (i.e., Press line key + *3 or the service
code set of Forced Trunk Disconnect in Program 11-10-26).