NEC Univerge SV9100 - Selectable Display Messaging

1061
Selectable Display Messaging
Description
An extension user can select a programmed Selectable Display Message for their extension. Display
multiline terminal callers see the selected message when they call the user’s extension. Selectable
Display Messaging provides personalized messaging. For example, an extension user could select the
message GONE FOR THE DAY. Any display multiline terminal user calling the extension may hear a
DND signal and then see the message. See table below for a list of the standard messages.
An extension user can add digits for date, time or telephone number after messages 1~8 and 10 (up to
24 characters). For example, an extension user could select the message ON VACATION UNTIL and
then enter the date. Callers see the original message followed by the appended date. They could then
tell when the user is coming back from vacation. The system allows all telephones to use the Selectable
Display Messaging feature at the same time.
All telephones can use Selectable Display Messaging at one time.
The default messages are:
Selectable Display Messaging Defaults
No.
Message
Change “#” to...
1
IN MEETING UNTIL ##:##
Time (when meeting done)
2
MEETING ROOM - ########
Room Name or extension
3
COME BACK ##:##
Time (when returning)
4
PLEASE CALL ############
11 digits (telephone number)
5
BUSY CALL AFTER ##:##
Time (when returning)
6
OUT FOR LUNCH BACK ##:##
Time (when returning)
7
BUSINESS TRIP BACK ##/##
Date (when returning)
8
BUSINESS TRIP ##########
10 digits (where reached)
9
GONE FOR THE DAY
10
ON VACATION UNTIL ##/##
Date (when returning)
11~20
MESSAGE 11~20
Conditions
When Selectable Display Messaging is set as DND All, all other DND modes are canceled
when Selectable Display Messaging is canceled.
The Selectable Display Message will not display to the calling party's phone if there is
forwarding on the phone that set the Selectable Display, it will just follow the forwarding.
Default Settings
Enabled
System Availability