NEC Univerge SV9100 - To Redirect Calls to the Headset and Disable the Hookswitch; Using the Headset with Automatic Answer

1215
Program
Number
Program Name/Description
Input Data
Default
10-20-01
LAN Setup for External Equipment – TCP
Port
Define the TCP port/address/etc. for
communicating to external equipment.
0 ~ 65535
External Device
1 (CTI) = 0
External Device
2 ( MIS) = 4000
External Device
5 (SMDR
Output) = 0
External Device
6 (DIM Output) =
0
External Device
11 (O&M Server)
= 8010
External Device
12 (Traffic
Report Output) =
0
External Device
13 (Room Data
Output for Hotel
Service ) = 0
93-06-01
IP Address List – IP Address of 1st Party CTI
Client
Read only.
Indicates IP Address of 1st Party CTI client.
IP Address:
xxx.xxx.xxx.xxx
No Setting
93-06-02
IP Address List – Availability of 1st Party
CTI Connection
Read only.
Indicates Availability of 1st Party CTI client
connection.
0 = Not Available
1 = Available
No Setting
Operation
TAPI operation is automatic once programmed in the telephone system and enabled in the PC TAPI
application, unless a headset is used.
Using the Headset with Automatic Answer:
1. With the multiline terminal in an idle state, press the Help key.
2. Press the Headset key (Program 15-07 or SC 851: 05) twice.
3. Press the Exit key to return the display to idle.
 The Headset key blinks when Automatic Headset is activated.
 To cancel Automatic Headset, repeat these steps.
To redirect calls to the headset and disable the hookswitch (required for some TAPI features):
1. With the multiline terminal in an idle state, press the Help key.
2. Press the Headset key (Program 15-07 or SC 851: 05) twice.
3. Press the Exit key to return the display to idle.
 The Headset key blinks when Automatic Headset is activated.