NEC Univerge SV9100 - STD SIP Transfer - Unattended

738
Program
Number
Program Name/Description
Input Data
Default
15-05-16
IP Telephone Terminal Basic Data Setup –
Authentication Password
Assign the authentication password for SIP
single line telephones.
Maximum of 24 characters.
No Setting
15-05-18
IP Telephone Terminal Basic Data Setup – IP
Duplication Allowed Group
For an adapter that has one IP address coming
into it but multiple extensions off of it. Enable
this option for all extensions in the group so the
CPU knows that the one IP Address is assigned
to multiple extensions.
0 = Disable
1 = Enable
0
15-05-40
IP Telephone Terminal Basic Data Setup –
Calling Name Display Info via Trunk for
Standard SIP
Sets the incoming calling name display type on
a standard SIP terminal. Trunk name is the first
priority and abbreviated (SPD) name is second
priority.
0 = Both name and number
1 = Name only
2 = Number only
3 = None
0
15-05-43
IP Telephone Terminal Basic Data Setup –
Video Mode
Enable or Disable Video Mode for standard SIP
terminals.
0 = Disable
1 = Enable
0
15-05-49
IP Telephone Terminal Basic Data Setup –
Receiving SIP INFO
Select whether or not system can receive
DTMF from standard SIP phone via SIP INFO
message.
0 = Disable
1 = Allowed any time
2 = Allowed while RTP is not
available
1
STD SIP Transfer – Unattended:
Program
Number
Program Name/Description
Input Data
Default
15-05-50
IP Telephone Terminal Basic Data Setup –
Peer to Peer Mode
On a per station basis enable or disable Peer to
Peer mode.
0 = Disable
1 = Enable
1