NEC Univerge SV9100 - To Enable the Headset; To Use the Headset

541
Program
Number
Program Name/Description
Input Data
Default
15-02-43
Multiline Telephone Basic Data Setup –
Headset Ring Duration
If incoming ringing is set for headset, set the
duration the call rings the headset before
ringing the speaker.
0 = No Switch to Speaker Ring
1 = 10 seconds
2 = 20 seconds
3 = 30 seconds
4 = 40 seconds
5 = 50 seconds
6 = 1 minute
0
15-07-01
Programmable Function Keys
Assign a function key for Headset Operation
(code 05).
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
*
00 ~
*
99 (Appearance
Function Code) (Service Code
852 by default)
20-02-05
System Options for Multiline Telephones –
Headset Busy Mode
Set the conditions under which a headset
extension is busy to incoming callers:
The Headset extension is busy to incoming
callers when only one extension
appearance is busy (0).
- OR -
Headset extension is busy to incoming
callers only when both extension
appearances are busy (1).
0 = No
1 = Yes
0
20-02-12
System Options for Multiline Telephones –
Forced Intercom Ring (ICM Call Type)
Determine whether intercom calls should ring or
voice-announce extensions.
0 = Disable (Voice)
1 = Enable (Signal)
0
20-09-07
Class of Service Options (Incoming Call
Service) – Call Queuing
Turn Off or On an extension ability to have calls
queued if a call rings the extension when it is
busy.
Program 20-13-06 must be set to 0 (Off) for
this feature to work.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-13-06
Class of Service Options (Supplementary
Service) – Automatic Off-Hook Signaling
(Automatic Override)
Allow a busy extension user to Manually (0) or
Automatically (1) receive off-hook signals.
This setting is to receive incoming call
signaling information during call queuing.
0 = Off
1 = On
COS 1 ~ 15 = 1
Operation
To enable the headset:
1. Plug in the headset in the headset jack on the bottom of the telephone.
2. Program a Headset key (Program 15-07 or SC 851: 05).
 You hear a confirmation beep.
To use the headset: