NEC Univerge SV9100 - To Send Off-Hook Signals to an Extension Busy on a Call

932
Program
Number
Program Name/Description
Input Data
Default
20-13-05
Class of Service Options (Supplementary
Service) – Intercom Off-Hook Signaling
Turn Off or On an extension user ability to send
Off-Hook Signals.
This setting functions with Programs 20-09-07
and 20-13-06 disabled.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-13-06
Class of Service Options (Supplementary
Service) – Automatic Off-Hook Signaling
(Automatic Override)
Allow a busy extension to Automatically (1) or
Manually (0) receive off-hook Signals.
This setting is to receive incoming call
signaling information during call queuing.
0 = Off
1 = On
COS 1 ~ 15 = 1
20-13-34
Class of Service Options (Supplementary
Service) – Block Manual Off-Hook Signaling
Turn Off or On an extension user ability to block
off-hook signals manually sent from a
co-worker.
0 = Off
1 = On
COS 1 ~ 15 = 0
20-18-06
Service Tone Timers – Interval of Call
Waiting Tone
Set the time between off-hook Signaling alerts.
0 ~ 64800 seconds
10
80-01-01
Service Tone Setup – Repeat Count
Refer to Table 2-
(39)
Customize the system basic tones and system
31 Service Tone
service tones. The system must be reset for
the changes to take affect.
Setup Defaults,
Program
80-01-01
.
80-01-02
Service Tone Setup – Basic Tone Number
Refer to Table 2-
(39)
The following features require that the system
32 Service Tone
tones listed below be changed to match the
Setup, Program
table. After changing these settings the chassis
must be reset for the changes to take effect.
80-01-02
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
Operation
To send Off-Hook signals to an extension busy on a call:
Your extension may send off-hook signals automatically.
1. Dial 7.
- OR -
Press Off-Hook Signaling key (Program 15-07 or SC 851: 33).
 You hear ringback.
 To have your call voice-announce, dial 1.